Discriminator Forum

Data Slicers and Interfaces => Data Slicers and Interfaces => Topic started by: Torquetube on 05 Oct 2013, 17:39:08

Title: RS232 interface enclosure help
Post by: Torquetube on 05 Oct 2013, 17:39:08

Has anybody mounted their RS232 interface into an abs enclosure? I'm just looking at different ideas as to how to mount te pcb into a case. Any ideas?

Title: Re: RS232 interface enclosure help
Post by: VidarParry on 28 Nov 2013, 22:52:23
I haven't found a tidy way of doing this. Rene suggested plastic soap cases which would probably work for single interfaces, but where you have multiple interfaces (I have 4) finding something that is compact and can mount the boards whilst catering for the cables at both ends is tricky. I ended up putting insulation material between the boards and putting them in a plastic kit box with cable ties to keep them together. Not elegant, but works!

Ideally, you want something that can clamp or hold the sides of the boards whilst allowing visibility of the green LED. The edges don't have a lot to hold on to so maybe some firm non-conductive foam grip arrangement might be the way.

Title: Re: RS232 interface enclosure help
Post by: dudies69 on 25 Mar 2014, 04:20:46
    I have mounted many of the RS232 Interfaces using cheap Jiffy Boxes from Jaycar (link below). I actually solder separate panel RS232, 3.5mm and 2.1mm audio plugs onto the board with short cable runs. I cut out a slot for the RS232 plug on the box and drill holes for the audio and power plugs. I like these boxes as they are the exact size for the PCB board and that means they don’t move around much. Also being transparent means I can easily see if the LED is flashing as it is suppose to. I find they work really well. Just my two cents worth.


Title: Re: RS232 interface enclosure help
Post by: oz1jua on 18 Apr 2014, 12:51:03
I have manged to get the interface in one of these boxses. 90x56x23mm ABS Plastic Enclosure Small Project Box.
You can find it on ebay.
Title: Re: RS232 interface enclosure help
Post by: coyoteaus on 12 Jun 2014, 06:23:23
I can only offer what has worked so well for me.

Being old and needing glasses the company
I buy my specs from send me these plastic glasses cases.

I to tried various boxes so I took a knife to the ends of one of these cases
and made a hole in each end for cables and the board fits perfectly with leads coming
out each end  and I can see the little light working,  quick , dirty yet elegant. Yay :-)tre

Regards to the group