Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - deadman

Pages: [1]
PDW Support / Re: usb interface
« on: 13 Feb 2018, 16:26:46 »
All drivers have correctly installed, however apart from the previous Message, PDW (All Versions above 3.0) crash completely, so Im giving up.. Ive triple checked the wiring of the leads.. USB port = 2.0. the dip switches are set correctly, PDW is set up correctly..theres nothing else I can think of  >:(  :'(

PDW Support / Re: usb interface
« on: 13 Feb 2018, 08:47:16 »
latest message, nothing else decoded

PDW Support / Re: usb interface
« on: 13 Feb 2018, 06:45:40 »
My current setup is a UBC9000xlt with Discriminator tap, monitoring the paging system for the New Zealand Fire Service (Flex) on 157.9500. using eith Win Xp or Win 7 (Depending on what computer I want to use)
the drivers were loaded prior to using the interface, as I cannot find a dip switch setting map, i am guessing with each setup, currently (looking at the switches) (1) down (2) up. using mono earphone cable to banana socket via discriminator tap (non resistor)

PDW Support / usb interface
« on: 12 Feb 2018, 02:51:49 »
Hi Guys,
The USB Interface, does this work with USB2.0 or is it USB3.0 only, all Im getting via Win7 running PDW3.12 or PDW 3.20 beta is the Needle shaking, no decoding whatsoever.
Im using the official FTD drivers from a link on the Discriminator site (CDM12.12.28).

On my Xp machine, I can only use Soundcard, the computer doesnt automatically find the Interface drivers, and it comes up as a driver with the yellow triangle

PDW Support / Re: 4level slicer driver install
« on: 25 Apr 2016, 03:29:45 »
I too am having trouble installing the slicer, Previous installs on another computer worked well. but since getting an old multimedia computer and installing a serial card (high Speed), the slicer will not install

im interested in purchasing one of these, Been running PDW since concept.
Brought the serial interface a few years ago, but because I was lazy, I didnt out it in a case to protect it, and it broke.
I might have this wrong but this particular interface goes been the discrimator tap and the line input of the computer ??

is the result better than the serial interface..
at present still running XP for PDW and Selcall..
I have raw data feeding into PDW from discrimator point without the resistor and works abt 98% (Does have moments with antenna)

Pages: [1]