Messages

I've just tried deleting everything and downloading V3.12. I can now run this without asking to run install.exe but get a warning that the Com port cannot be opened. Once PDW is running I can now select Com1 and Com2 but the Soundcard selections are now greyed out?? Any ideas anyone. I have tried running as administrattor and compatability mode but no success.

Phl...

I am using PDW to decode ACARS and Pocsag via soundcard with reasonable success but want to try using the RS232 interface I purchased some time ago. I can run Install.exe OK but it ends with message 'Driver Installer Failed'.

When I run PDW the interface does not allow me to select COM port, the boxes are all greyed out, I can only select soundcard. Anyone any advice?

Running Win10. Have tried running in Compatability Mode WinXP but no change.

Phil...

Thanks for reply, I'll have to work on that one.

Regards

Can anyone tell me what the yellow triangle containing an exclamation mark next to the level meter indicate? I'm assuming it is a warning of some kind but I am getting good decodes and the triangle doesn't disappear if I change levels. Using sound card, decoding Flex.

Phil...

Thanks for reply Rene, I've had a read of the link and whilst I can't yet get my head around the actual workings of the new interface, I can understand the principle. Looks like I need to order a new interface a soon as the Xmas postal madness has subsided. It'll give me time to read more about the workings.

Regards Phil...

I've just had to upgrade PC and am now on Win8.1. For XP I successfully used a Hamcom interface (from JVComm all those years ago) and it worked fine. I have installed a PCIe Serial card in the new PC but can't seem to get any signal showing on PDW. I have used the serial card with other programs (not decoding but comms work fine).

Does anyone know if I need an upgraded interface or should the Hamcom interface still work with Win8.1?

Regards Phil