Messages

1

PDW Support / Re: PDW after Discriminator do not work

« on: 30 Apr 2018, 14:28:26 »

Hello Steve

Thanks for prompt reply, you gave me an idea when you wrote that PDW is not receiving any data. I'll check the cable from scanner, try changing the 3.5mm connector. Have read on forum that part says that you have a mono contact while others say you should have a stereo contact. I'll try this one of the next few days and return with the result before proceeding with the config file.

Once again thank you for your help so far

/G

2

PDW Support / PDW after Discriminator do not work

« on: 27 Apr 2018, 17:51:03 »

Hello, I have a problem that I hope someone can help me with.

I have a UBC760XLT that I connected to the computer and pdw, I received a lot of message, however, only with junk. Therefore, I did a Discriminator Tap on my scanner, but now I do not get any message at all on it. The pointer, RX-Q on the upper right indicates nothing at all on POCSAG, but the meter shows allmost full on MOBITEX and a little on ACARS.

I have tried a lot of different settings, such as the computer's internal sound card, exclusive USB sound card, change the volumes, mono 3.5mm connector, stereo 3.5mm connector.

Anyone who has an idea of what might be the error or what i have done wrong?