English Menubar Nederlandse versie Homepage News Order Information Order Frequently Asked Questions

PRO-2035 / PRO-2042



picture

The Realistic PRO-2035 and PRO-2042 are almost identical. The scanner can be opened by removing 4 screws on the back. Slide the complete case half a centimeter back, and remove the top lid. If you disconnect the loudspeaker PCB-connector, the scanner is easier to handle.

PRO-2035 / PRO-2042

There are 2 options for a discriminator output: directly to pin 9 of the discriminator IC, a TK10420. Or to TP2 (test point 2), which is connected to this IC directly. If you choose for the last option, you don't have to solder to the IC.

picture

picture

TP2, close to pin 9 of the 10420 receiver IC

A 10 k resistor connects TP2 to the outside world

A 10 k resistor is soldered to TP2. The resistor's other lead is connected to a 3.5 mm chassis plug, which can be mounted in the back of the scanner. The resistor's leads have been isolated with isolation material from a piece of wire.

Since the back panel of the scanner is connected to the scanners's ground, no separate ground lead is necessary from the 3.5 mm connector.



© 2003- 2023 discriminator.nl



Valid HTML 4.01 Transitional Valid CSS!

Map